Logger Script iVA Series - Cable and Antenna Analyzers | Kaelus ::NUBICOM::
top
New Products

  • 개요 및 주요특징
  • 기술 사양
  • 주문 정보
  • 문서 자료

케이블 및 안테나 분석기

iVA 시리즈 케이블 및 안테나 분석기는 사용자가 RF 인프라에서 VSWR / 반사 손실 오류를 정확하게 측정하고 찾을 수있게 해주는 Kaelus의 흥미로운 신제품입니다. 무선 연결성은 전례없는 측정 유연성을 제공하며 스윕 테스트 및 멀티 포트 테스트에서 새롭고 중요한 가능성을 열어줍니다. iVA는 Bluetooth 지원 타블렛, 스마트 폰, 랩탑 컴퓨터 또는 iPA 시리즈 휴대용 수동 혼합 분석기를 사용하여 원격으로 제어 할 수있는 견고한 배터리 작동 모듈입니다.

주요특징

  • 사이트 인증 스윕 테스트 재발견, 현장 테스트 시간 단축
  • 여러 iVA를 사용하는 경우 삽입 손실 및 격리를 직접 측정합니다. 단일 iVA 및 RF 단락으로 계산 된 삽입 손실 측정
  • n RF 경로에서 VSWR / 반사 손실 및 거리 - 대 - 오류를 정확하게 측정합니다.
  • 태블릿 PC에 간단하고 강력한 블루투스 연결 또는 연결 랩탑 컴퓨터에 USB 또는 블루투스 연결
  • 테스트중인 장치에 직접 연결하십시오. 필요성을 없애 준다. 대부분의 경우 위상 안정성 케이블
  • Kaelus에서 입증 된 iPA보고 워크 플로 및 태그 기능을 사용하여 보다 빠르고 간단하고 효율적인 워크 플로우를 촉진합니다.
  • Kaelus iPA로 iVA를 제어하면 RL 데이터를 다음과 결합 할 수 있습니다. PIM 데이터를 단일 보고서로 보고서는 현장에서 결합되어 완성됩니다. (사후 처리가 필요 없음)
  • 작동하기 쉽고 직관적 인 소프트웨어 사용자 인터페이스 온 사이트에서 테스트 보고서를 생성하고 완성하는 독특한 능력
  • 각 테스트 포인트에 위치 정보 태그 지정, Google Maps® 스냅 샷 삽입 간섭 체크를위한 핸디 스펙트럼 모니터 모드
  • 자극 모드는 iVA가 신호 생성기로 사용될 수 있도록 합니다. 여러 주파수를 순환하도록 구성 할 수 있으며, 각 주파수에서 사용자 정의 드웰 시간이 표시됩니다.


기술 사양

KEY SPECIFICATIONS
iVA analysis modes Return loss, VSWR, Cable loss, Distance-to-fault (DTF), Transmission loss, Isolation, Spectrum monitor, Channel power
Frequency range 560MHz - 2750MHz
Minimum frequency increment 1kHz all modes
Number of measurement points 1 to 2191


ELECTRICAL
DC power consumption 102 x 368 x 445mm | 4 x 14.5 x 17.5in
Return loss mode 4.7W
Transmission mode 4.7W
Spectrum monitor mode 3.7W
Standby (Idle) 0.6W
Battery Lithium-Ion 3.6V, 2350 mAh, 8.5Wh
Battery charging method USB-compatible power source connected to USB port of iVA
Battery operating time 8 Hours at typical usage factor


IVA ANALYSIS MODE - RETURN LOSS
Sweep speed 4ms per frequency point
RF Output power 0dBm ± 3dB
Return loss dynamic range 40dB
VSWR Dynamic range 1 - 100:1
Cable loss measurement range* 0 - 20dB
Return loss measurement accuracy Applies over the temperature range −10°C to +45°C, with less than 5°C deviation from calibration temperature.
0 - 10dB ± 0.4dB
10 - 20dB ± 0.6dB
20 - 30dB ± 0.6dB
30 - 40dB ± 4.0dB
Calibrated directivity ± 4.0dB
Interference immunity +10dBm at 500kHz offset from stimulus frequency
System impedance 50ohms
* Cable loss can be measured either as a 1-port measurement, with the far end of the cable terminated in an open or short circuit, or directly measured for increased accuracy as a 2-port measurement using a second iVA


IVA ANALYSIS MODE - MULTI-PORT TRANSMISSION (OPTIONAL FEATURE)
Sweep speed 10ms per frequency point
RF Output power 0dBm ± 3dB
Dynamic range 0dB
Transmission loss measurement accuracy Accuracy specifications only applicable where return loss of DUT is greater than 10dB.
0 - 10dB ± 1dB
10 - 60dB ± 2dB
60 - 90dB ± 3dB
Interference immunity
0 - 60dB -5dBm at 500kHz offset from stimulus frequency
60 - 100dB -25dBm at 500kHz offset from stimulus frequency
The iVA offers a novel multi-port S-parameter test capability using multiple iVAs. Up to 7 units can be connected simultaneously via Bluetooth, while up to 32 can be connected via USB. As an example, 6 iVAs could be used to perform measurements on a multi-port antenna. This configuration would cover all 36 transmission pathways (6x6), including the return loss at each port (6 measurements), and the transmission loss between every possible pair of ports (30 measurements). Return loss measurements made by the iVA contain both magnitude and phase information, while transmission loss measurements are limited to magnitude only.


IVA ANALYSIS MODE - SPECTRUM MONITOR
Sweep speed 2ms per frequency point
Measurement range
Low power range -35 to -115dBm (software default)
High power range -+20 to -50dBm
Receiver noise figure (low power range) 15dB
Resolution bandwidth 20kHz
Displayed average noise level (RBW = 20kHz) -115dBm low power range, -50dBm high power range
Measurement accuracy ±3dB
Maximum input power without damage +23dBm
Input IP3 (low power range) +18dBm
Interference immunity
Low power range −25dBm at 500kHz offset from stimulus frequency (software default)
High power range −5dBm at 500kHz offset from stimulus frequency
Return loss at iVA test port 10dB minimum / 15dB typical


IVA ANALYSIS MODE - CHANNEL POWER MODE
Measurement modes (See Note 1) CW signal mode Modulated signal mode Occupied bandwidth Adjacent channel power ratio
Dynamic range in CW mode
Low power range −100 to −35dBm
High power range −45 to +15dBm
Minimum detectable signal in modulated mode
Low power range (See Note 2) 10 log(B) − 87dBm
High power range (See Note 2) 10 log(B) − 32dBm
Maximum detectable signal in modulated mode
Low power range (See Note 2) Min(−0.5, 10 log(B) – 14) dBm
High power range +15dBm
Power measurement accuracy (See Note 3) ± 1.5dB typical ± 3dB maximum
Measurement channel bandwidth
CW mode 1kHz to 20MHz
Modulated mode 1kHz to 2190MHz
Maximum number of measurement channels (See Note 4) 1
Sweep speed 2ms per frequency point
Maximum input power without damage +23dBm
Note 1 Occupied Bandwidth and Adjacent Channel Power Ratio features to be included in future release of Kaelus Unify application software.
Note 2 B is the occupied bandwidth of the measured signal in MHz.
Note 3 Assumes aggregate RF power of all signals entering the test port is less than the iVA's input P1dB point.
Note 4 Future releases of Unify will allow the user to define up to 10 simultaneous measurement channels across the frequency range of interest.


STIMULUS MODE
Number of carriers
Minimum 1
Maximum Unlimited
Dwell time
Minimum 500ms
Maximum Unlimited
RF output power 0dBm ± 3dB


INSTRUMENT CONTROL
User interface USB or Bluetooth supported user device with iVA application software installed
Supported Devices iPA Portable PIM Analyzer
Tablet computer (iOS & Android)
Smartphone (iOS & Android)
PC, Windows 7,8 & 10 running .NET verson 4 or later
Communications interface to iVA Bluetooth and USB 2.0
Bluetooth antenna Integrated into housing
Maximum input power on RF port +23dBm maximum, DC voltage ±30V


MECHANICAL
Dimensions H x D x W 52 x 69.5 x 216mm | 2.06 x 2.73 x 8.51in
Weight 0.68kg | 1.5 lbs
Connector 1 RF test port
iVA-0627A: Type N male, 50 ohms
iVA-0627B: 4.3-10 male, 50 ohms
Connector 2 USB 2.0 Mini-B (for charging and connection to iPA or PC)
Mechanical Shock & Vibration MIL-PRF-28800F Class 2, ETS 300 019-2-1, -2, -7


ENVIRONMENTAL
Temperature range -10°C to +55°C | +14°F to +131°F (operational)
Ingress protection IP54
Altitude 4600m | 15,000ft maximum
Compliance EMC- EN 61326-1:2013, EN 61326-2-1:2013, EN 55022:2010 "Class A"
EN 61000-4-2, 4-3, 4-4, 4-5, 4-6, 4-11
Safety- EN 61010-1:2012, EN 61010-030:2012
Operational humidity 5% to 95% RH non-condensing
Storage temperature range -20°C to +60°C | -4°F to +140°F

주문 정보

Part Number Description
iVA-0627A-NC iVA Cable & Antenna Analyzer System, Type N male connector with Neoprene Soft Case
iVA-0627A-HC iVA Cable and Antenna Analyzer System, Type N male connector with Hard Case
iVA-0627A-BK iVA Cable & Antenna Analyzer System,Type N male connector with Basic Accessory Kit
iVA-0627A-SK-02 iVA Cable & Antenna Analyzer System, Type N male connector with Standard Accessory Kit
iVA-0627A-PK-02 iVA Cable & Antenna Analyzer System, Type N male connector with Premium Accessory Kit
iVA-0627B-NC iVA Cable & Antenna Analyzer System, 4.3-10 male connector with Neoprene Soft Case
iVA-0627B-HC iVA Cable and Antenna Analyzer System, 4.3-10 male connector with Hard Case
iVA-0627B-BK iVA Cable & Antenna Analyzer System, 4.3-10 male connector with Basic Accessory Kit
iVA-0627B-SK-02 iVA Cable & Antenna Analyzer System, 4.3-10 male connector with Standard Accessory Kit
iVA-0627B-PK-02 iVA Cable & Antenna Analyzer System, 4.3-10 male connector with Premium Accessory Kit


ACCESSORY KITS

iAK-0200A-00 Single unit Hard Case Kit, USB Cables and Charger
iAK-0200A-01 Single unit Hard Case Kit w/ Adaptors, USB Cables and Charger
iAK-0200A-02 Single unit Hard Case Kit w/ Adaptors and N Type Female Calibration Kit, USB Cables and Charger
-03 N Type Male Calibration Kit
-04 DIN Female Calibration Kit
-05 DIN Male Calibration Kit
iAK-0210A-02 Premium Hard Case Kit w/ Adaptors, Calibration Kit, Phase Stable Cable, USB Cables and Charger
-03 N Type Male Calibration Kit
-04 DIN Female Calibration Kit
-05 DIN Male Calibration Kit
iAK-0200B-01 Single unit Hard Case Kit w/ Adaptors, USB Cables and Charger
iAK-0200B-06 Single unit Hard Case w/ Adaptors, 4.3-10 Female Calibration Kit, USB Cables and Charger
-07 4.3-10 Male Calibration Kit
iAK-0210B-06 Premium Hard Case Kit w/ Adaptors, Phase Stable Cable, 4.3-10 Female Calibration Kit, USB Cables and Charger
-07 4.3-10 Male Calibration Kit


HOW TO ORDER

Kaelus offers our customers a variety of channels to fit their network and delivery requirements:
Direct from Kaelus -contact our customer service team at +1.303.768.8080 or toll free at +1.800.498.1352 for technical support, unit pricing and availability. Distribution Partners: Our US and Canada distribution partners have the full line of iVA series products available for your use. Contact informationcan be found on our website under partners at www.kaelus.com.

IVA SERIES
IVA SERIES
IVA SERIES

문서 자료

제목 다운받기
iVA 시리즈 데이터시트 다운로드
  • 가족친화우수기업
  • 청년친화 강소시업
사업자등록번호 : 220-86-72761대표이사 : 신동만대표전화 : 070-7872-0701팩스 : 02-2167-3801
(우)07299 서울특별시 영등포구 경인로 775 (문래동 3가, 에이스하이테크시티 3동 2층)